1, Idle: When the new matrix is used for the first time, it needs to be idle for about 30 minutes. In summer, the high-temperature season needs to run with water. The purpose is to further eliminate the influence of the welding head on the matrix, and to strengthen the saw blade in high speed rotation. The memory of intrinsic quality.
2, blocks should not be less than 0.5m3, and placed securely, the bottom should be pad square wood, solid solid plug, blocks should be located in the symmetrical position of the table to ensure that the stability of the work car and blocks, no shaking , Shivering phenomenon.
3, according to Huangliao the length, width, height adjustment stroke switch, so that the saw blade lift and the material of the trip in a solid and effective range. Saw blade before cutting blade should be separated from the maximum 10 ~ 20mm. After sawing, saw the mouth from the bottom of the block should be left 20-40mm, saw blade walking around the knife before the operation, the saw blade should be all out of the sawing block, the interval shall not be less than 150-200mm, to avoid impact material.
4, the blade can be stopped in front of the stability of idle cutting, not allowed to see blade edge contact with the Huangliao start when the saw blade, cutting is not allowed to stop the saw blade rotation, to be withdrawn from the saw mouth before the stop.
5, cutting if found to have rock slump should immediately stop cutting, to be fixed in front of solid blocks can continue to work, cutting, are not allowed to arbitrarily move Huangliao.
6, cutting saw blade saw a significant deceleration as well as the phenomenon of clamping knife, it may be belt slippage, loose nuts or eat knife too deep, take the knife speed through fast and other reasons, should be promptly adjusted.
7, the line speed and processing of stone hardness and wear resistance, the initiative to select the table below the line speed cutting different types of stone.
Tip: In line speed is not high, increase the cutting efficiency, will reduce the service life of the saw blade.